 Top Entry |
 |
| |
With extension arm for use with
lower water levels |
|
|
| Top Entry Trough |
• |
Thread Valve into existing trough fitting |
• |
Determine the on/off point and water level required |
• |
Use supplied Adjustable Extension Arm when a larger air gap/lower water level is required |
• |
Adjust the float and arms to suit required angle |
|
| |
| Bottom Entry |
Side Entry |
|
|
|
TO CHANGE ON/OFF & WATER LEVEL
Adjust the length of the cord at the top of the float |
| Bottom or Side Entry Trough |
• |
Thread Valve into existing trough fitting |
• |
Thread cord through the float, adjust cord to required on/off level then tie off |
|
| |
| Tank Installation: |
• |
Install tank fitting into water tank |
• |
Flush lines into water tank before installing Valve into system |
• |
Thread O-Ring end of correct size male adaptor into valve body and tighten firmly enough that the O-Ring creates a seal against the face. Do not over tighten. |
• |
Thread Valve into Tank Fitting inside tank |
• |
Thread cord through the float, adjust cord to required on/off level then tie off. |
| |
|
|
