Find a Stockist near you
Valve Accessory.
115mm Threaded Float HiViz fits Fastflo and Superflo or other valves with Brass Arm or Cord. Also fits top of Hansen Tank Level Alert Indicator arm.
Yes, the Super-Flo trough Valve incorporates a 25mm (1”) thread on the valve outlet which you can utilise the spare adaptors that come with the valve to enable you to attach any number of poly pipe fittings to the Super-Flo trough Valve. This off take can be used for any number of farm applications.
Yes, valve bounce is created from high flows at high pressures, because our Hansen Super-Flo valve delivers higher flows than other valves it will effectively reduce line pressure which in return will reduce the incidences of this problem by also reducing water hammer.
Yes, the Fast-Flo valve has the highest flow of any valve in its class/size. At 500 kPa (73psi) it will deliver 56 l/min
The noise while the tank is filling is caused by the high velocity of the water from the valve outlet into the tank. The Fast-Flo valve outlet doubles as a spigot so you can attach a length of hose to allow the flow to be placed onto the bottom of the tank eliminating this noise.
Hansen understands the value of your time and with the Hansen Level Alert there are no ropes and pulleys, tubes or smoke and mirrors, only time tested strength of glass fibre reinforced nylon and the proven ability of Hansen’s Innovative simple effective design.
Yes, the Hansen Level Alert comes with stainless steel fasteners for installation on steel, plastic and concrete tanks.
No, the seat we use in Hansen Float Valves are urethane which is a very durable and hard material. The seal is also reversible if a foreign body should damage it.
We have designed the Hansen Super-Flo valve to work in either clean or dirty water situations.
Yes, we have covered this issue in two ways, firstly by incorporating a HiViz UV Stabilised low wind resistant float and secondly our glass reinforced nylon guide tube and larger diameter stainless steel tube (16mm diameter) reduces the chance of it bending reducing this problem.
Yes, our fully adjustable UniTri mounting base will adapt to most tank roof angles, the adjustment is a full 35 degrees each way, so once installed you never need to adjust.
Yes, the Hansen Super-Flo Valve comes with the required components to install in 20mm or 25mm threaded inlets. This of course means you only need to buy one valve for all sized inlets.
Yes, the Fast-Flo Valve has the arm pivot point positioned to allow closing at pressures up to 12 bar (174psi) with a 115mm float attached.
Yes, the Hansen Super-Flo valve has a new patent pending “Slipper Fit Piston” design seal assembly to minimise this problem.
The Hansen Sueper-Flo Valve will operate from 0.2 bar to 12 bar.
All Hansen float valves carry a 25mm (1”) female thread on the valve inlet. This gives you a couple of benefits. The valve will fit inlets from 15mm to 50mm when using our range of adaptors. The additional material used at the inlet to form the female thread strengthens the valve at an area that has been identified as a weak point in other brands of valves.
Yes, the Fast-Flo was designed as a compact valve for use in small bowls, compact troughs, feeders & header tanks or any situation where the valve space is confined.
No, because the Hansen Super-Flo valve is more efficient than what you are used to. The reduced operating pressure required will equate to higher flows at lower pressures at your pump which in turn will reduce pumping time and cost.
