Find a Stockist near you
Replacement Part for Hansen Leveller Valve, Rapidflo Valve & Sloflo Valve.
Plunger Housing Assembly (Roller, Plunger, Spring, Plunger Housing).
Yes, our range of HiFlo Valves are designed to handle dirty water. The Hansen Leveller Valve which is based on our diaphragm valves it is unique in that it has a pin that cleans the pilot hole in the diaphragm every time it opens and closes. In addition to that the gap between the diaphragm and the valve body when open is a huge 14mm further reducing potential blockages.
Yes, this is called cycling and can drastically reduce the life of your pump. The Hansen Leveller Valve is designed to control your pump safely by eliminating pump cycling and providing an adjustable water differential depth in your tank.
Yes, you will find the reservoir valve you are using at the moment is only supplying a flow close to your irrigation demand, with the Hansen Leveller Valve the flow delivery will be much higher and will allow your bore pump to run for less time as well as setting a differential in the tank to enable your pump to shut off for sensible periods.
Yes, as long as your pumps are sized correctly to cover your peak demand the Hansen Leveller Valve will help by delivering a much higher flow at much lower pressure e.g. 400kPa (58 psi) = 772 l/min (170 gpm).
Yes, both the Slo-Flo and Rapid-Flo Rain Relief Valves are designed to handle dirty water.
The Leveller Valve opens when a pre-defined minimum water level is reached and will fill your entire tank. The Rain Relief Valve will only supplement your tank with either 50mm or 100mm of water, depending on the float orientation.
The Rapid-Flo and Slo-Flo Rain Relief Valves are essentially the same valve. The key difference between them is that the Rapid-Flo valve is capable of functioning at full flow rate whereas the Slo-Flo valve is restricted to 2 l/min to conform to the Sydney Water Guidelines.
